SuzukiSavage.com - Print Page

SuzukiSavage.com
/cgi-bin/YaBB.pl
General Category >> Rubber Side Down! >> Relocate rear turn signals
/cgi-bin/YaBB.pl?num=1121401311

Message started by Paladin on 07/14/05 at 21:21:51

Title: Relocate rear turn signals
Post by Paladin on 07/14/05 at 21:21:51

Don't remember who asked, but.....

http://savage.andruschak.net/FTP/ReLocTailLight1.jpg http://savage.andruschak.net/FTP/ReLocTailLight2.jpg http://savage.andruschak.net/FTP/ReLocTailLight3.jpg http://savage.andruschak.net/FTP/ReLocTailLight4.jpg

The relocate kit came with my Leatherlyke Saddlebags and consisted of a piece of angle iron, a piece of wire, and some wire splices -- all of which should be obtainable locally.

After disconnecting and removing the rear turn signals, mount them to the bracket. Remove license plate and remount with the turn signal backet now attached to the license plate bracket. Snake wires thru the center hole of the turn signal bracket, wraptie to tail light wires. Remove grommet, snake a thin wire alongside the taillight wires, attach to turn signal wires and pull back thru the same path as the tail light wires. Enlarge center hole of grommet and replace. Stretch tail light wires with provided wire/splices and reconnect. Test. Re-reconnect correctly (it's a 50-50 chance unless you label, and easier to reconnect than to label.)

Title: Re: Relocate rear turn signals
Post by Greg_650 on 07/15/05 at 06:24:26

That was me. Thanks.

Oh yeah, nice vanity plate, too :P