SuzukiSavage.com - Print Page

SuzukiSavage.com
/cgi-bin/YaBB.pl
General Category >> Rubber Side Down! >> Jetting Suggestion
/cgi-bin/YaBB.pl?num=1159472190

Message started by jmerry on 09/28/06 at 12:36:30

Title: Jetting Suggestion
Post by jmerry on 09/28/06 at 12:36:30

Can someone suggest a main and pilot jet for an 06 with an HD muffler mod, at around 2000 ft elevation?

Thanks!

Title: Rlar: Jetting Suggestion
Post by georgekathe on 09/28/06 at 12:56:27

hope you get help you need, but seem to recall one response to a similar question (correctly, I guess) said every bike is a little different) & I assume what is done to white spacer will also need taking into account.

george ;)

Title: Re: Jetting Suggestion
Post by jmerry on 09/28/06 at 13:07:57

Oh yes. I've taken the white spacer down to 1/2. I'm guessing that I would need a 152.5 main and 55 pilot.. But, I'm open to suggestions of the experienced.. Also, to change these, I hope I don't have to pull the tank again! Getting the top screws out was a job! Do you just pull the bowl for the jet change?

Thanks!

Title: Re: Jetting Suggestion
Post by vroom1776 on 09/28/06 at 13:50:54

152.5 main sounds good, but the 55 pilot sounds big... what was the stock size on yrs?

Title: Re: Jetting Suggestion
Post by Guido on 09/28/06 at 14:48:17

stock on an 05 is 52.5

Title: Re: Jetting Suggestion
Post by vroom1776 on 09/28/06 at 15:10:58

okay, 55 should be okay.... unless the PMS screw is less than 1 turn out. If the PMS screw is more than 3 turns out with the 52.5, definitley go with the 55

Title: Re: Jetting Suggestion
Post by azjay on 09/29/06 at 07:02:56

jmerry wrote:

I hope I don't have to pull the tank again! Getting the top screws out was a job! Do you just pull the bowl for the jet change?!

you dont need to pull the tank, but you need to remove the seat, top of the carb, throttle cable, loosen the two mounting clamps, then you can rotate the carb to get bowl screws, remove the bowl, change the jets, reassemble.

Title: Re: Jetting Suggestion
Post by jmerry on 09/29/06 at 07:17:08

Anyone know of a good vendor for these jets? I think I've seen a post somewhere..

Title: Re: Jetting Suggestion
Post by vroom1776 on 09/29/06 at 07:19:24

local shop should have them

Title: Re: Jetting Suggestion
Post by jmerry on 09/29/06 at 07:30:08

They should.. But, I couldn't even find one that carried our oil filters.. I had to have the K&N one ordered special.