SuzukiSavage.com /cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Side stand diode /cgi-bin/YaBB.pl?num=1416450527 Message started by Jeff71 on 11/19/14 at 18:28:46

Title: Side stand diode Post by Jeff71 on 11/19/14 at 18:28:46 Gang, The blue and black wire coming out of the diode to the neutral light. (2003) Can you simply disconnect that? I'm working on the wiring for the acewell gauge and there is no place for it to go. Jeff

Title: Re: Side stand diode Post by Dave on 11/20/14 at 02:51:11 If you are wiring in the neutral light in the Acewell - you want to splice it into the wire that goes to the neutral light indicator on the stock speedometer.  Same for the turn signal and high beam indicators....it is best just to go to the indicator lights on the stock speedo and splice into those wires. When you get into the RYCA build - the side stand diode will be removed and you will then use the blue wire from the neutral switch.

Title: Re: Side stand diode Post by Jeff71 on 11/20/14 at 17:46:40 Just putting this out there so you can see what I'm working on.http://i264.photobucket.com/albums/ii173/mode4eng/S40wiringtruelayout_zpsf01f7c99.jpg (http://s264.photobucket.com/user/mode4eng/media/S40wiringtruelayout_zpsf01f7c99.jpg.html) Jeff

SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved.