SuzukiSavage.com - Print Page

SuzukiSavage.com
/cgi-bin/YaBB.pl
General Category >> Rubber Side Down! >> Decompression Lever Install
/cgi-bin/YaBB.pl?num=1612317821

Message started by gtenginerd on 02/02/21 at 18:03:41

Title: Decompression Lever Install
Post by gtenginerd on 02/02/21 at 18:03:41

Is there a video or clear explanation of the decomp solenoid and circuit removal and lever Install? I've scoured the internet and see discussions, but nothing comprehensive. I'm trying to figure out if this is something that I should tackle while I have the bike apart. I don't mind trying and documenting in the build thread, if it's not too hard, and I can figure out what I'm doing.

Title: Re: Decompression Lever Install
Post by Gary_in_NJ on 02/02/21 at 19:16:56

@Dave

Do you have a kit you could sell to this gentleman?

Title: Re: Decompression Lever Install
Post by verslagen1 on 02/03/21 at 07:20:37

http://suzukisavage.com/cgi-bin/YaBB.pl?num=1556134192/1#1

Title: Re: Decompression Lever Install
Post by Dave on 02/03/21 at 10:03:28

464C48424940444D131511210 wrote:

@Dave

Do you have a kit you could sell to this gentleman?

No - I got enough BMX levers, cable and parts to build 6 of those kits - and I sold them all years ago. I am not looking to get back into the business of making/selling them.

Title: Re: Decompression Lever Install
Post by LANCER on 02/03/21 at 10:16:33

It requires a 2” piece of wire and a bolt.

Title: Re: Decompression Lever Install
Post by gtenginerd on 02/04/21 at 19:39:08

I was thinking this was a simple lever installed on top of the engine block, and removal of the solenoid and circuit. Doesn't look that straightforward :(

Title: Re: Decompression Lever Install
Post by verslagen1 on 02/04/21 at 19:52:19

you can do it that way, but you need to disable the clutch safety too.