SuzukiSavage.com
/cgi-bin/YaBB.pl
General Category >> Rubber Side Down! >> Dyna muffler help
/cgi-bin/YaBB.pl?num=1633120680
Message started by dougiestyle on 10/01/21 at 13:38:00

Title: Dyna muffler help
Post by dougiestyle on 10/01/21 at 13:38:00
I went ahead and installed... sorta installed... the Dyna muffler. My only issue is the angle off the header pipe seemes to be angled inward. I saw this was a common problem through the other posts. All I could find is to get some exhaust pipe at a 10degree bend and have it welded together. Is this the best option or is there other options before welding it? Also does anyone know the diameter of exhaust pipe I would need for this?

Title: Re: Dyna muffler help
Post by DragBikeMike on 10/01/21 at 15:17:25
Dougie, you can make the required adapter with some simple hand tools and a cheap Map gas torch.  This post gives some fairly detailed instructions.  Make the sleeve used to fill the gap between the adapter and the header pipe about half as long as the one shown in the post (about 1 to 1.25" long).  

http://suzukisavage.com/cgi-bin/YaBB.pl?num=1623048749


VHT Flame Proof paint (black or silver) dolls it up nicely, and these Evil Energy clamps work good.

Good luck, Mike

Title: Re: Dyna muffler help
Post by dougiestyle on 10/05/21 at 03:17:39

10161965676064540 wrote:
Dougie, you can make the required adapter with some simple hand tools and a cheap Map gas torch.  This post gives some fairly detailed instructions.  Make the sleeve used to fill the gap between the adapter and the header pipe about half as long as the one shown in the post (about 1 to 1.25" long).  

http://suzukisavage.com/cgi-bin/YaBB.pl?num=1623048749


VHT Flame Proof paint (black or silver) dolls it up nicely, and these Evil Energy clamps work good.

Good luck, Mike



Mike,
Thank you. I plan on attempting this either this weekend or next. Nice tutorial BTW.

Doug

SuzukiSavage.com » Powered by YaBB 2.2!
YaBB © 2000-2007. All Rights Reserved.