SuzukiSavage.com - handlebar risers

Welcome, Guest. Please Login or Register :: View Members

SuzukiSavage.com › General Category › Rubber Side Down! › handlebar risers

(Moderators: verslagen1, Dave, Serowbot)

‹ Previous topic | Next topic ›

Pages: 1

handlebar risers (Read 13 times)

john1652 Ex Member	handlebar risers 12/11/06 at 12:02:09 hey it's almost Christmas, I am wanting to lower my handlebars on my 07 savage. It came with the tall pull back risers and drag bars and it looks cool. I turned the risers around and it gave me more room, but I really want that lowered look. Has anyone done this and what risers did you use? Savages seem to run great in the cold and snow.
Back to top	IP Logged

Five_Points Full Member Offline Posts: 141 Columbus, OH	Re: handlebar risers Reply #1 - 12/11/06 at 13:13:12 I too was wondering. I have the pullback bars that were stock on my 95' Savage. I just got some drag bars but the controls will hit the tank with the stock Risers. I was wondering what the smallest size risers I could get that'd clear the tank yet keep the bars as low as I can.
Back to top	IP Logged

babbalou

Serious Thumper

Offline

Posts: 814
Lewisville, Texas
Gender: male

Re: handlebar risers
Reply #2 - 12/11/06 at 19:34:30

http://www.ronayers.com/fiche/300_0372/steering_stem/steering_stem.cfm?man=su...
I hope this link works. I removed the risers, (part 10 here) on my 2005. I bolted the handlebar clamp directly on to the triple clamp. I had to get 2 long bolts & 2 nuts from the hardware store for that, sorry I can't remember the size. The stock drag bar hit the sides of the tank this way but I put on an HD Sportster handlebar & it works great. Feels good too. Before that, the bar was too close, narrow & high up for me.

Had an S40 Jul '04-Jan '07

IP Logged

verslagen1 YaBB Moderator ModSquad Offline Where there's a will, I want to be in it. Posts: 29042 L.A. California Gender:	Re: handlebar risers Reply #3 - 12/11/06 at 23:28:13 I just replaced my buckhorn with an emco bar with about 3 or 4" of rise and 3 or 4" of pull back with the standard clamps. Not bad for $25, just a little short in width and height. shifted the bar a 1/4" to the right and a tie wrap to keep the throttle cable from clanging against the tank.
Back to top	Versey's Place Tech Section Index IP Logged

Pages: 1

‹ Previous topic | Next topic ›

« Home