SuzukiSavage.com - carburetor repairs

Welcome, Guest. Please Login or Register :: View Members

SuzukiSavage.com › General Category › Rubber Side Down! › carburetor repairs

(Moderators: verslagen1, Dave, Serowbot)

‹ Previous topic | Next topic ›

Pages: 1

carburetor repairs (Read 62 times)

PipJones Full Member Offline Posts: 146 Fort Worth, Tx Gender:	carburetor repairs 10/24/08 at 07:04:16 anybody know a good place to get a carb repair kit. i need to rip into mine, but i don't know what gaskets/o-rings i'm gonna need. thanks for the help Pip Jones
Back to top	Gargle, sputter, burp and die!!! The ways of my LS650!!!!! IP Logged

Serowbot

YaBB Moderator
ModSquad

Offline

OK.... so what's the
speed of dark?

Posts: 29698
Tucson Az
Gender: male

Re: carburetor repairs
Reply #1 - 10/24/08 at 10:38:31

I f you're not rejetting, you probably don't need anything. Modern carbs use o-ring gaskets, not crummy paper, so they are usually good for several teardowns and rebuilds. I've been into mine a half dozen times.
It's a good idea to replace the factory phillips head screws with hex heads for future teardowns. 4 on the top and 4 on the bottom (floatbowl). They are M5 metric, can't remember the lengths. Take one out of the top and one out of the bottom and buy 4 of each.

Ludicrous Speed !... ... Huh

...

IP Logged

srinath Serious Thumper Offline I love YaBB 1G - SP1! Posts: 5349	Re: carburetor repairs Reply #2 - 10/24/08 at 10:56:13 My 87 and 86 had paper float bowl gasket, but all else was O ring. You can make the paper ones out of ... like a beer carton that doesn't have the glossy paint on the outside. Cool. Srinath.
Back to top	IP Logged

PipJones Full Member Offline Posts: 146 Fort Worth, Tx Gender:	Re: carburetor repairs Reply #3 - 10/24/08 at 13:36:36 i think i may need to rejet as well. would i just need to buy the jets, or will i need more gaskets, etc.?
Back to top	Gargle, sputter, burp and die!!! The ways of my LS650!!!!! IP Logged

Serowbot YaBB Moderator ModSquad Offline OK.... so what's the speed of dark? Posts: 29698 Tucson Az Gender:	Re: carburetor repairs Reply #4 - 10/24/08 at 14:19:40 Just jets, one main, one pilot,...#4 washers if you do the needle jet mod...1 nylon or 2 metal, looking for .066" thick, .1" is stock. I used the nylon available at Ace hardware and others. Info in the tech section. Jets go in from the bottom, floatbowl Spacer from the top, slide, watch for big floppy spring on top. Good luck,
Back to top	Ludicrous Speed !... ... ... IP Logged

PipJones Full Member Offline Posts: 146 Fort Worth, Tx Gender:	Re: carburetor repairs Reply #5 - 10/24/08 at 14:59:11 thanks for all the help!!!!
Back to top	Gargle, sputter, burp and die!!! The ways of my LS650!!!!! IP Logged

Pages: 1

‹ Previous topic | Next topic ›

« Home