SuzukiSavage.com - Serowbot, I can show you the way...

Welcome, Guest. Please Login or Register :: View Members

SuzukiSavage.com › General Category › The Cafe › Serowbot, I can show you the way...

(Moderators: verslagen1, Dave, Serowbot)

‹ Previous topic | Next topic ›

Pages: 1

Serowbot, I can show you the way... (Read 89 times)

Built2Last Serious Thumper Offline Tempt Fate Posts: 1447 FTF Gender:	Serowbot, I can show you the way... 09/13/11 at 15:07:20 To this magical paradise... just please put in a #155 main for me and a 55 pilot.. I don't have a shop...
Back to top	IP Logged

verslagen1 YaBB Moderator ModSquad Offline Where there's a will, I want to be in it. Posts: 28996 L.A. California Gender:	Re: Serowbot, I can show you the way... Reply #1 - 09/13/11 at 15:23:06 oooooooooooooooooooooo, tin can land.
Back to top	Versey's Place Tech Section Index IP Logged

Serowbot

YaBB Moderator
ModSquad

Offline

OK.... so what's the
speed of dark?

Posts: 29294
Tucson Az
Gender: male

Re: Serowbot, I can show you the way...
Reply #2 - 09/13/11 at 16:17:19

No problem!... Come on over!... I got a tiny 12 x 12ft shop, but it'll do... Wink

...

Nice cans!... Your cupboard is very tidy!... Grin

...

Seriously,... you don't need a shop for that job... just a really good screwdriver and about 20 minutes...
Loosen the boot clamps,...
Tilt the carb toward you little...
Take out the floatbowl screws... (might need to pull the battery and box)...
remove and swap the jets...
Put things back...

Easy as toast... Wink

...

Ludicrous Speed !... ... Huh

...

IP Logged

Built2Last

Serious Thumper

Offline

Tempt Fate

Posts: 1447
FTF
Gender: male

Re: Serowbot, I can show you the way...
Reply #3 - 09/13/11 at 16:33:23

20 minutes you say? I might as well go read it up in the tech forum again.. I just can't run that RAASK till I do it... and if I have to take it back to the Suzuki place again because I stripped something... eh heh... they already think I'm a bit off cause I joked around and called my bike a Harley...

I usually burn my toast Angry

IP Logged

Built2Last Serious Thumper Offline Tempt Fate Posts: 1447 FTF Gender:	Re: Serowbot, I can show you the way... Reply #4 - 09/13/11 at 16:47:09 Shall I grab any of these brand spankin' new tin cans? If they fall off the fork lift and touch the ground they can't be used, therefore there's a lot laying around...
Back to top	IP Logged

mmosel

Senior Member
2005 No Login

Offline

My bike is
officially THUMPING
now.

Posts: 415
NW Oregon
Gender: male

Re: Serowbot, I can show you the way...
Reply #5 - 09/13/11 at 17:17:05

Just be carrreful trying to get that pilot jet out. It's a bit tricky and if it's tight, you could start stripping it. They are soft.

Also, be careful when replacing the main. Don't 'push' on it or it'll retreat into the hold. Don't forget the washer... and carefully and gently rethread the new jet in there. If you can do them both without taking the carb off, you've scored big time...

Definitely take the battery and battery box out.

Finally, you may wish to replace the bowl screws with stainless hex bolts and lock washers. And while you're at it, get a solo allen wrench for them. Only about 75 cents or something.

Finally, you're gonna need a small and short screw driver to get that pilot out.

Good luck.

IP Logged

Pages: 1

‹ Previous topic | Next topic ›

« Home