SuzukiSavage.com - Belt pully cover mesh mod

Welcome, Guest. Please Login or Register :: View Members

SuzukiSavage.com › General Category › Rubber Side Down! › Belt pully cover mesh mod

(Moderators: verslagen1, Dave, Serowbot)

‹ Previous topic | Next topic ›

Pages: 1 2

Belt pully cover mesh mod (Read 279 times)

verslagen1

YaBB Moderator
ModSquad

Offline

Where there's a
will, I want to be
in it.

Posts: 28995
L.A. California
Gender: male

Re: Belt pully cover mesh mod
Reply #15 - 09/23/13 at 09:34:45

Yup, looks great

except for the aesthetics, which suck. Grin

The front is vertical and looks like it matches the shift pattern inset - OK
The top edge would be better if it was horizontal or followed the belt or followed the top of the cover.
The rear edge would be better if it was vertical or followed the rear edge of the cover.
The bottom edge isn't near anything so it's just fine.

Corners should be all identical.

Versey's Place
Tech Section Index

IP Logged

babyhog Serious Thumper Offline On two wheels... again Posts: 3805 WV Gender:	Re: Belt pully cover mesh mod Reply #16 - 09/23/13 at 09:38:00 Ah! Well that makes sense. Just a couple other observations.... where'd you get the tank badge and enrichment knob? Neat looking. And your pegs are not stock either. You probably documented them while I was MIA, but where did they come from and how hard were they to install?
Back to top	~ Hairdo by Helmet! ~ IP Logged

ToesNose Serious Thumper Offline Pardon me, do you have Hot Sauce? Posts: 1993 Mooresville, NC Gender:	Re: Belt pully cover mesh mod Reply #17 - 09/23/13 at 11:28:30 The tanks badges are Celtic Cross belt buckles, and I think the enricher handle was originally a necklace that was floating around in my tool chests for years. Nothing but love for you Versey, nothing but love
Back to top	The Suzuki LS650, bringing Miles of Smiles everywhere! IP Logged

Bubba Serious Thumper Offline SuzukiSavage.com Rocks! Posts: 956 Denver, CO Gender:	Re: Belt pully cover mesh mod Reply #18 - 09/23/13 at 14:38:03 speaking of celtic...you could have carved a celtic cross in it and backed it with mesh...that would have been a lot of cutting tho'...
Back to top	'06 lt Blue, Dyna Power pipe, air screw 2 1/4 turns, 52.5 pilot w/ bleed holes, 150 Main, 2/3 spacer, Pirelli MT66 tires, Raptor petcock, 412-4006 Progressive shocks IP Logged

njrmahoney Junior Member Offline SuzukiSavage.com Rocks! Posts: 51	Re: Belt pully cover mesh mod Reply #19 - 09/23/13 at 18:09:40 Looks good, I want to do the same for under my new seat
Back to top	seat_mod_7_001.jpg IP Logged

Pages: 1 2

‹ Previous topic | Next topic ›

« Home