SuzukiSavage.com - I am in Chinese, questions about ryca.

Welcome, Guest. Please Login or Register :: View Members

SuzukiSavage.com › General Category › Rubber Side Down! › I am in Chinese, questions about ryca.

(Moderators: verslagen1, Dave, Serowbot)

Pages: 1 2

I am in Chinese, questions about ryca. (Read 240 times)

Dave YaBB Moderator ModSquad Offline SuzukiSavage.com Rocks! Posts: 18313 Camp Springs, Kentucky Gender:	Re: I am in Chinese, questions about ryca. Reply #15 - 02/21/15 at 06:00:14 Superxin wrote on 02/21/15 at 05:07:47: How long steel of 18"rim? Measurements are in this thread for the front hub: http://suzukisavage.com/cgi-bin/YaBB.pl?num=1424132735
Back to top	Someday I will be old......But not today! IP Logged

Superxin YaBB Newbies Offline SuzukiSavage.com Rocks! Posts: 27	Re: I am in Chinese, questions about ryca. Reply #16 - 02/21/15 at 06:36:56 cool! i need it.thank you very much. happy newyear
Back to top	IP Logged

Superxin YaBB Newbies Offline SuzukiSavage.com Rocks! Posts: 27	Re: I am in Chinese, questions about ryca. Reply #17 - 02/21/15 at 06:39:01 ...... The back spokes of 18'rim.....?
Back to top	IP Logged

Dave YaBB Moderator ModSquad Offline SuzukiSavage.com Rocks! Posts: 18313 Camp Springs, Kentucky Gender:	Re: I am in Chinese, questions about ryca. Reply #18 - 02/21/15 at 09:12:24 The rear spoke is 5-3/4" (146mm) from the tip of the threads to the start of the bend. You need 18 spokes bent to 80 degrees (88.89 grads), and 18 spokes bent to 95 degrees (105.56 grads). Those spokes are for use with an Excell rim....if you have a different rim the diameter at the spokes could be different.
Back to top	Someday I will be old......But not today! IP Logged

Pages: 1 2

« Home