SuzukiSavage.com - Temperature readings

raydawg Serious Thumper Offline SuzukiSavage.com Rocks! Posts: 11551 pacific northwest Gender:	Temperature readings 05/13/15 at 04:54:29 With infrared technology cheap now, does anyone know of, or has tried rigging a sensor to measure our motor temp? Seems like it's doable, yes?
Back to top	“The biggest big business in America is not steel, automobiles, or television. It is the manufacture, refinement and distribution of anxiety.”—Eric Sevareid (1964) IP Logged

Dave

YaBB Moderator
ModSquad

Offline

SuzukiSavage.com
Rocks!

Posts: 18317
Camp Springs, Kentucky
Gender: male

Re: Temperature readings
Reply #1 - 05/13/15 at 05:13:29

Handheld infrared stuff is cheap and affordable and provides a good diagnostic tool for mechanics. And professional race teams use it to monitor tire temperatures while on the track...all really useful stuff for them.

For our bikes.....normal eletric sensors and gauges are more practical. My Trail Tech Vapor had a temperature gauge....I have no idea how accurate it was. I mounted the sender to the left rear cylinder stud at the head.

On the back roads in the summer cruising around at 30-50 mph the head temperature was around 240 degrees. Interstate travel at speeds up to 70 mph would get up to 280 degrees. When the temperature climbs over 90.....on the interstate or stuck in downtown traffic I got close to 300 degrees a few times.

Once I did the Kawasaki pulley conversion - the 70 mph cruise temperatures dropped 20 degrees as a result of the lower rpm.

My new speedometer does not have a temperature gauge...I am going to miss it. (I like knowing what my engine is doing).

Back to top

Someday I will be old......But not today!

IP Logged

raydawg Serious Thumper Offline SuzukiSavage.com Rocks! Posts: 11551 pacific northwest Gender:	Re: Temperature readings Reply #2 - 05/13/15 at 05:55:29 Wow Dave, that seems hot. Isn't heat the biggest factor in lubrication failure?
Back to top	“The biggest big business in America is not steel, automobiles, or television. It is the manufacture, refinement and distribution of anxiety.”—Eric Sevareid (1964) IP Logged

Dave

YaBB Moderator
ModSquad

Offline

SuzukiSavage.com
Rocks!

Posts: 18317
Camp Springs, Kentucky
Gender: male

Re: Temperature readings
Reply #3 - 05/13/15 at 06:34:18

The temperature I listed was the cylinder head just a few inches from the combustion chamber....it is not the crankcase and/or oil temperature. I also did not check the gauge to see how accurate it was......the temperature reading the Trailtech showed for the air temperature was always reading about 15 degrees high.

Air cooled engines do run hotter than water cooled ones....that is why most modern bikes that are performance oriented are water cooled.

Back to top

Someday I will be old......But not today!

IP Logged

Oldfeller--FSO

Serious Thumper
ModSquad

Offline

Hobby is now
"concentrated
neuropany"

Posts: 12686
Fayetteville, NC
Gender: male

Re: Temperature readings
Reply #4 - 05/13/15 at 06:41:08

That is why some of us use Rotella Synthetic -- because nothing we can ever do will ever cause the RotSyn oil to fail.

Dave still uses Dino, which is fine -- historically, we have very few lubrication failures that were not caused by running low on oil in the first place (or else by running gas contaminated oil from a bad vac petcock -- durn those blasted vacsuckers).

Back to top

Former Savage Owner

IP Logged

Serowbot YaBB Moderator ModSquad Offline OK.... so what's the speed of dark? Posts: 29299 Tucson Az Gender:	Re: Temperature readings Reply #5 - 05/13/15 at 06:59:00 On air-cooled bikes in the desert,... I believe ignorance is the best policy... ...
Back to top	Ludicrous Speed !... ... ... IP Logged

Arnold Serious Thumper Offline The dude abides... Posts: 896 Westchester, NY Gender:	Re: Temperature readings Reply #6 - 05/13/15 at 07:07:39 "Alive in Tucson" - Last Man on Earth.
Back to top	IP Logged

verslagen1 YaBB Moderator ModSquad Offline Where there's a will, I want to be in it. Posts: 28996 L.A. California Gender:	Re: Temperature readings Reply #7 - 05/13/15 at 07:17:59 You can use these... http://suzukisavage.com/cgi-bin/YaBB.pl?num=1361141824 You can get them to fit the sparkplug or a headbolt. They also fit on the front pressure test plug.
Back to top	Versey's Place Tech Section Index IP Logged

Gary_in_NJ

Serious Thumper

Offline

LS650 Cafe Racer

Posts: 2645
Amongst the Twisty Roads

Re: Temperature readings
Reply #8 - 05/13/15 at 09:43:48

I would,'t worry too much about operating temps in the mid-200's. Air/oil cooled engines run high CHT's.

On the Lycoming O-320 in my homebuilt aircraft the green operating zone is between 250 to 375F, yellow is 375 to 430F and red is above that. The CHT Thermocouple is mounted fairly deep in the head, very close to the point of combustion. I know that for engines where there isn't a probe mount there are sparkplug adapters that mount between the sparkplug and the cylinder head.

BTW, EGT's run 1,100 to 1,600F with 1,300 +/- 100 being normal.

Back to top

A life-time student of motorcycling.
LS650 Cafe, DRZ400SM, FZ6N, SV650S, CB900C, Ducati ST2, CB550F-SS
My LS650=> http://suzukisavage.com/yabb2.2/Attachments/Left.JPG

IP Logged

justin_o_guy2 Serious Thumper Offline What happened? Posts: 55279 East Texas, 1/2 dallas/la.	Re: Temperature readings Reply #9 - 05/13/15 at 10:14:45 Cheap, affordable, yeah, accurate? I've got a HF one, sometimes it tells me something that just doesn't make sense, but it also sometimes seems right. I have 2 thermometer I check my Basal temperature with, digital, same company, sometimes they agree, sometimes they are .3 or so degrees apart.
Back to top	The people never give up their liberties but under some delusion.- Edmund Burke. IP Logged