SuzukiSavage.com - fuse block Wiring Diagram

Welcome, Guest. Please Login or Register :: View Members

SuzukiSavage.com › General Category › Rubber Side Down! › fuse block Wiring Diagram

(Moderators: verslagen1, Dave, Serowbot)

‹ Previous topic | Next topic ›

Pages: 1 2 3

fuse block Wiring Diagram (Read 441 times)

verslagen1

YaBB Moderator
ModSquad

Offline

Where there's a
will, I want to be
in it.

Posts: 28996
L.A. California
Gender: male

Re: fuse block Wiring Diagram
Reply #30 - 05/18/24 at 19:18:56

Arty Dodger wrote on 05/18/24 at 17:23:37:

I’m not sure either on the spade terminals. The switch I’m using is this one: https://www.amazon.com/your-orders/pop?ref=ppx_yo2dv_mob_b_pop__np_1_pp&order...

I have one of them going to ground and the other is going to the igniter. Indicated from this diagram. It does say to connect the igniter wire to the starter motor wire but the igniter wire is 16ga and the starter is 4ga wire.

That's not a good link.

If you had the OEM harness, they connect the igniter to the starter with a ring terminal on the 16ga wire (I think it's smaller) connected to the post of the starter wire.

Versey's Place
Tech Section Index

IP Logged

Arty Dodger Junior Member Offline SuzukiSavage.com Rocks! Posts: 51 Shreveport, LA Gender:	Re: fuse block Wiring Diagram Reply #31 - 05/18/24 at 19:24:29 Oh I see! Yea I didn’t get the oem harness from previous owner. I’ll try that. After of course I buy another battery. 4th times the charm, right?! I can move the spade to a ring and add it to the post of the starter wire. Do you think the ground is good in the spade terminal part?
Back to top	2007 Suzuki Savage to Bob or Die! IP Logged