SuzukiSavage.com - Premade gasket or gasket maker sealer?

Hazuki

YaBB Newbies

Offline

SuzukiSavage.com
Rocks!

Posts: 6

Premade gasket or gasket maker sealer?
08/26/23 at 14:44:29

I’m replacing the clutch on my 2002 Hazuki. I was told to use a premade gasket then put gasket maker on both sides. It was a horrible mess gasket maker didn’t want to stick to the metal. After I cleaned that up someone said use spray adhesive on the premade gasket that faces the engine side and gasket maker on the clutch cover side. Can anyone clear it up for me?

Back to top

IP Logged

Moarpower Senior Member Offline SuzukiSavage.com Rocks! Posts: 331	Re: Premade gasket or gasket maker sealer? Reply #1 - 08/26/23 at 15:19:56 You don't need any sealer. You could put a small dab where the sensor wire comes out but that's it.
Back to top	IP Logged

verslagen1

YaBB Moderator
ModSquad

Offline

Where there's a
will, I want to be
in it.

Posts: 28996
L.A. California
Gender: male

Re: Premade gasket or gasket maker sealer?
Reply #2 - 08/26/23 at 19:48:42

Hazuki wrote on 08/26/23 at 14:44:29:

I’m replacing the clutch on my 2002 Hazuki. I was told to use a premade gasket then put gasket maker on both sides. It was a horrible mess gasket maker didn’t want to stick to the metal. After I cleaned that up someone said use spray adhesive on the premade gasket that faces the engine side and gasket maker on the clutch cover side. Can anyone clear it up for me?

Sometimes you might need all that (like after butchering the sealing surfaces after trying to scrape all that off) but I never have.

And I've used OEM and aftermarket gaskets. Just coat with a light coat of oil so it doesn't stick to the case permanently except around the oil channel.

Back to top

Versey's Place
Tech Section Index

IP Logged

Dave

YaBB Moderator
ModSquad

Offline

SuzukiSavage.com
Rocks!

Posts: 18314
Camp Springs, Kentucky
Gender: male

Re: Premade gasket or gasket maker sealer?
Reply #3 - 08/27/23 at 03:54:39

I do the same as Verslagen.....I install gaskets without applying any sealer and use sealer where the bike came with sealer from the factory.

The use of sealer on gaskets is not necessary as long as the gasket is in good shape.

If you put the gasket on dry......chances are that the next time you take things apart it will have stuck to one or both sides and tear when you take things apart. A light coating of oil as Verslagen suggested keeps the gasket from sticking. The factory gaskets have a thin line of adhesive in specific places...don't oil the gasket in those locations.

Back to top

Someday I will be old......But not today!

IP Logged