SuzukiSavage.com - Cut & Forget

Welcome, Guest. Please Login or Register :: View Members

SuzukiSavage.com › General Category › Rubber Side Down! › Cut & Forget

(Moderators: verslagen1, Dave, Serowbot)

‹ Previous topic | Next topic ›

Pages: 1

Cut & Forget (Read 23 times)

Pipi

YaBB Newbies

Offline

SuzukiSavage.com
Rocks!

Posts: 2

Cut & Forget
07/15/24 at 11:35:13

I am almost a month busy to make a bobber (my first but will be one of the nicest) and I am busy with the wiring. (downloaded a simplified diagram from this Forum.

Because a lot of wires are tooo long I started cutting to shorten. So I did also with the 3 yellow cables that has to go to the RECTIFIER ... Pretty smart he...

Can somebody tell me which yellow cable goes where on te rectifier?

geel_001.png

IP Logged

verslagen1 YaBB Moderator ModSquad Online Where there's a will, I want to be in it. Posts: 28995 L.A. California Gender:	Re: Cut & Forget Reply #1 - 07/15/24 at 12:28:13 The 3 wires come from a 3 phase AC generator and go to the rectifier. Typically full wave rectifiers take AC and convert it to DC and it doesn't matter which wire is attached to which terminal just as long as you don't tie all 3 wires together you'll be ok.
Back to top	Versey's Place Tech Section Index IP Logged

ThumperPaul

Serious Thumper

Offline

SuzukiSavage.com
Rocks!

Posts: 2154
Houston, Texas
Gender: male

Re: Cut & Forget
Reply #2 - 07/15/24 at 12:33:32

You butchered that. Those wires need to be 36" long and they go to the alternator (stator or AC generator as Versy calls it). (left side engine cover near the front pulley).

With the rectifier in its normal position on the rear fender, the wires would run from there to behind the battery box, under the back side of the motor, through a channel alongside the front pulley and then into the left side engine cover near the front pulley.

IP Logged

Pages: 1

‹ Previous topic | Next topic ›

« Home