Just two positions for the enrichment? The carb on my "Other" Suzuki single, seems to be positionable in multiple, what I would call "continuously variable" different positions, at least I treat it that way. What position it starts out in, depends on how cold the weather when I'm starting. And how it progresses through the "positions" depends on how quickly the engine warms up.
I'll have to look closer at my LS650 when it comes out of storage.
I saw this thread, comparing a few different carbs on a Savage:
http://suzukisavage.com/cgi-bin/YaBB.pl?num=1585461605There seems to be a lot of range, one can have success with, from a
Keihin knockoff PWK38 for ~$40,
Mikuni knockoff VM38 for ~$50,
Genuine Keihin PWK38, around $100,
Genuine Mikuni VM38, around $125,
There's also the Mikuni TM, flat slide series, which again can be found as knockoff and genuine article. These weren't included in the carb shootoff, but are on my radar.
I like the idea of getting rid of the extra complexity and the manifold vacuum reliance of the stock CV type carb, but I'm aware of some potential challenges.
- The throttle mechanisms for the direct acting carbs are mainly all single cable, while the CVs generally have two cables.
- I understand that a lot of carbs come setup for 2 strokes. Not sure what differences this entails.
- Jetting for a lot of "carb in a box" will be generic. The internals can be remarkably complicated.
For example, I noticed when I had the BSR32 out of my GZ250, between the needle jet, jet needle, pilot, main, starting, and several air jets, there were 7 components to pick correctly, plus needle shim positions and mixture screws to set. A surprising LOT of things to know, select, and adjust.
I have started making efforts to learn enough to have confidence with a carb swap, but, so far have mainly gained an appreciation for how little I know of what it is possible to know.