SuzukiSavage.com - Double RYCA build Mar 2019 updates

verslagen1 YaBB Moderator ModSquad Offline Where there's a will, I want to be in it. Posts: 28996 L.A. California Gender:	Re: Double RYCA Build Reply #150 - 03/25/12 at 17:53:26 Hell? figured you for WHEAT!
Back to top	Versey's Place Tech Section Index IP Logged

BuckRYCA Senior Member Offline Posts: 258 New London, CT, USA Gender:	Re: Double RYCA Build Reply #151 - 03/25/12 at 17:59:24 You Double Build guys have been at it for a while! Yesterday I turned 3,500 miles on my Ryca.
Back to top	« Last Edit: 03/25/12 at 19:45:48 by BuckRYCA » '96 Savage - now a Ryca CS-1 IP Logged

Gyrobob

Serious Thumper

Offline

Posers ain't
motorcyclists

Posts: 2571
Newnan, GA
Gender: male

Re: Double RYCA Build
Reply #152 - 03/26/12 at 06:59:49

BuckRYCA wrote on 03/25/12 at 17:59:24:

You Double Build guys have been at it for a while! Yesterday I turned 3,500 miles on my Ryca.

Yeah, we shoulda been there too. We even got a fairly early start. I won't go into the reasons why, but the reality is that we are about 90% done and we're trying to finish them up now before it gets hot.

Now I have this electrical problem.

Back to top

If you think there's good in everyone, you haven't met everyone.

IP Logged

Gyrobob Serious Thumper Offline Posers ain't motorcyclists Posts: 2571 Newnan, GA Gender:	Re: Double RYCA Build Reply #153 - 03/26/12 at 09:31:43 I found it. It was the jumper I had put in place of the sidestand relay.
Back to top	If you think there's good in everyone, you haven't met everyone. IP Logged

sbaugz Ex Member	Re: Double RYCA Build Reply #154 - 03/26/12 at 18:59:18 BuckRYCA wrote on 03/25/12 at 17:59:24: You Double Build guys have been at it for a while! Yesterday I turned 3,500 miles on my Ryca. was just thinking the same thing
Back to top	IP Logged

Gyrobob

Serious Thumper

Offline

Posers ain't
motorcyclists

Posts: 2571
Newnan, GA
Gender: male

Re: Double RYCA Build
Reply #155 - 04/11/12 at 20:37:41

Two new items (four actually, two each) came in the mail today. A solid state flasher so the turn signals blink at a normal rate, and a blue LED to use as the high beam indicator.

I wanted to have a blue high beam indicator in the stock headlight bucket, but there isn't much room between the headlight innards and the shell. I found these tiny and flat blue LED thingies that will take up almost no space at all inside the bucket. I already have them wired into the high beam wiring. They may be too bright.

Here's a video showing turning the key to on, which then shows the flash rate, and the blue LED I'm holding.

Back to top

If you think there's good in everyone, you haven't met everyone.

IP Logged

Gyrobob Serious Thumper Offline Posers ain't motorcyclists Posts: 2571 Newnan, GA Gender:	Re: Double RYCA Build Reply #156 - 04/12/12 at 13:06:08 Here's how we handled the sidestand switch. Put heat-shrink tubing over the two wires soldered together.
Back to top	If you think there's good in everyone, you haven't met everyone. IP Logged

Gyrobob Serious Thumper Offline Posers ain't motorcyclists Posts: 2571 Newnan, GA Gender:	Re: Double RYCA Build Reply #157 - 04/12/12 at 13:26:06 I have a less than marvy trust in double-stick tape, so we are locating the ignition box as shown below. The piece of metal is just some scrap from the shop. The hole in the top lines up with the existing threaded hole, and the bottom is just a bolt and nut fit through a hole in the bottom of the battery box.
Back to top	« Last Edit: 04/13/12 at 04:51:45 by Gyrobob » If you think there's good in everyone, you haven't met everyone. IP Logged

wombat

Full Member

Offline

SuzukiSavage.com
Rocks!

Posts: 109

Re: Double RYCA Build
Reply #158 - 04/12/12 at 15:27:38

I too had no faith in holding the igniter in place with just tape. So I trimmed down the stock bracket that the rubber sleeve slides onto, pop riveted the modified bracket to the battery box, and slipped the sleeved igniter onto the bracket. Neat, clean and simple.

Gyrobob wrote on 04/12/12 at 13:26:06:

I have a less than marvy trust in double-stick tape, so we are locating the ignition box thusly:

http://i258.photobucket.com/albums/hh253/Gyrobob_theOriginal/Motorcycle/RYCA%...

http://i258.photobucket.com/albums/hh253/Gyrobob_theOriginal/Motorcycle/RYCA%...

Back to top

IP Logged

Gyrobob Serious Thumper Offline Posers ain't motorcyclists Posts: 2571 Newnan, GA Gender:	Re: Double RYCA Build Reply #159 - 04/13/12 at 05:51:17 Decompression controller bypass jumper
Back to top	If you think there's good in everyone, you haven't met everyone. IP Logged

Cavi Mike Serious Thumper Offline Thumper n00b Posts: 1005 Rochester, NY Gender:	Re: Double RYCA Build Reply #160 - 04/13/12 at 06:25:13 Are you bypassing the solenoid because you're putting a lever on it?
Back to top	IP Logged

Gyrobob

Serious Thumper

Offline

Posers ain't
motorcyclists

Posts: 2571
Newnan, GA
Gender: male

Re: Double RYCA Build
Reply #161 - 04/13/12 at 07:58:40

Cavi Mike wrote on 04/13/12 at 06:25:13:

Are you bypassing the solenoid because you're putting a lever on it?

Yes. The solenoid and controller have been removed, and the RYCA linkage has been installed.

update Nov 2012 -- quite a bit of fiddling is involved in getting that linkage to operate smoothly, not rattle, and to make sure the exhaust valve is allowed to fully close.

Back to top

« Last Edit: 02/04/13 at 20:18:47 by Gyrobob »

If you think there's good in everyone, you haven't met everyone.

IP Logged

Gyrobob Serious Thumper Offline Posers ain't motorcyclists Posts: 2571 Newnan, GA Gender:	Re: Double RYCA Build Reply #162 - 04/13/12 at 19:02:08 ~~Instead of using the horn wires for instrument power (I'm still using the stock horn setup), I'm pulling the power out of the otherwised unused plug for the old instrument panel~~. no
Back to top	« Last Edit: 07/25/12 at 06:50:18 by Gyrobob » If you think there's good in everyone, you haven't met everyone. IP Logged

verslagen1 YaBB Moderator ModSquad Offline Where there's a will, I want to be in it. Posts: 28996 L.A. California Gender:	Re: Double RYCA Build Reply #163 - 04/13/12 at 19:55:05 mating connector hp9L I think http://www.vintageconnections.com/
Back to top	Versey's Place Tech Section Index IP Logged

Gyrobob Serious Thumper Offline Posers ain't motorcyclists Posts: 2571 Newnan, GA Gender:	Re: Double RYCA Build Reply #164 - 04/13/12 at 20:19:25 Fantastic site, Vers !!! What a find!
Back to top	If you think there's good in everyone, you haven't met everyone. IP Logged